Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Is there an adjustment

View previous topic View next topic Go down 
AuthorMessage
DPete

avatar


PostSubject: Is there an adjustment    Thu Mar 13, 2014 9:57 am

on the clutch pack? Did searches only turned up cable adjustment, owners manual same thing. 2013 wr
Back to top Go down
YZEtc

avatar


PostSubject: Re: Is there an adjustment    Thu Mar 13, 2014 8:06 pm

Yes, and it is the same principle as most Yamaha dirt bikes.
It's in chapter 5 of the Yamaha Service Manual.
Why?
Back to top Go down
DPete

avatar


PostSubject: Re: Is there an adjustment    Thu Mar 13, 2014 8:26 pm

Getting the most out of a clutch means keeping it adjusted correctly, I'll see if I can find it online
Back to top Go down
ezrdr55

avatar


PostSubject: Re: Is there an adjustment    Fri Mar 14, 2014 8:53 am

I only have 200 miles on my WRR so I have not personally done this. I just read the procedure in the shop manual. Apparently there is a lever arm, I'm guessing at the end of the clutch cable, that has a "pointer" on it that needs to align with a line on it's bracket. Looks like you push up on the arm till it stops and the two should be aligned. If it is not aligned you have to adjust the clutch push rod adjustment screw found in the middle of the clutch pressure plate. I'm not sure if there is an access screw or if you have to remove the clutch cover. Clutch lever free play is in the owners manual. I hope that helps.
Back to top Go down
Fuzzy Wrench

avatar


PostSubject: Re: Is there an adjustment    Fri Mar 21, 2014 2:06 am

if you've reassembled your clutch after service, you may have to adjust the push rod....the pointer and line at the cable holder must line up with slight pressure..you can adjust that with the set screw and lock nut in the center of the clutch itself...most of my clutch adjustments are made with the bike on the side stand with minimal oil loss...clutch cable free play, that's another thing..
Back to top Go down
Sponsored content




PostSubject: Re: Is there an adjustment    

Back to top Go down
 
Is there an adjustment
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» KTM 400 Mixture screw adjustment.
» Rear Ride Height Adjustment - 924, 944, 968
» Valve Adjustment Question
» Doing my own valve adjustment
» Fox shock adjustment

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: