Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 Is there an adjustment

Go down 
4 posters
AuthorMessage
DPete

DPete



Is there an adjustment  Empty
PostSubject: Is there an adjustment    Is there an adjustment  EmptyThu Mar 13, 2014 9:57 am

on the clutch pack? Did searches only turned up cable adjustment, owners manual same thing. 2013 wr
Back to top Go down
YZEtc

YZEtc



Is there an adjustment  Empty
PostSubject: Re: Is there an adjustment    Is there an adjustment  EmptyThu Mar 13, 2014 8:06 pm

Yes, and it is the same principle as most Yamaha dirt bikes.
It's in chapter 5 of the Yamaha Service Manual.
Why?
Back to top Go down
DPete

DPete



Is there an adjustment  Empty
PostSubject: Re: Is there an adjustment    Is there an adjustment  EmptyThu Mar 13, 2014 8:26 pm

Getting the most out of a clutch means keeping it adjusted correctly, I'll see if I can find it online
Back to top Go down
ezrdr55

ezrdr55



Is there an adjustment  Empty
PostSubject: Re: Is there an adjustment    Is there an adjustment  EmptyFri Mar 14, 2014 8:53 am

I only have 200 miles on my WRR so I have not personally done this. I just read the procedure in the shop manual. Apparently there is a lever arm, I'm guessing at the end of the clutch cable, that has a "pointer" on it that needs to align with a line on it's bracket. Looks like you push up on the arm till it stops and the two should be aligned. If it is not aligned you have to adjust the clutch push rod adjustment screw found in the middle of the clutch pressure plate. I'm not sure if there is an access screw or if you have to remove the clutch cover. Clutch lever free play is in the owners manual. I hope that helps.
Back to top Go down
Fuzzy Wrench

Fuzzy Wrench



Is there an adjustment  Empty
PostSubject: Re: Is there an adjustment    Is there an adjustment  EmptyFri Mar 21, 2014 2:06 am

if you've reassembled your clutch after service, you may have to adjust the push rod....the pointer and line at the cable holder must line up with slight pressure..you can adjust that with the set screw and lock nut in the center of the clutch itself...most of my clutch adjustments are made with the bike on the side stand with minimal oil loss...clutch cable free play, that's another thing..
Back to top Go down
Sponsored content





Is there an adjustment  Empty
PostSubject: Re: Is there an adjustment    Is there an adjustment  Empty

Back to top Go down
 
Is there an adjustment
Back to top 
Page 1 of 1
 Similar topics
-
» Sag Adjustment
» CO Adjustment
» Headlight adjustment
» TPS adjustment
» CO adjustment

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: