Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 Clutch not disengaging

Go down 
2 posters
AuthorMessage
Gath3r13

Gath3r13



Clutch not disengaging Empty
PostSubject: Clutch not disengaging   Clutch not disengaging EmptyFri Jun 20, 2014 9:11 am

Ive recently noticed that in my garage with the bike off, when I pull the clutch lever and roll the bike there is still quite a bit of friction. Like the clutch isn't fully disengaged.
Its a 2013 with 900 miles. I don't believe it was like this before. Anyone else notice this, or have any input on it?

Any info greatly appreciated.

Back to top Go down
4play

4play



Clutch not disengaging Empty
PostSubject: Re: Clutch not disengaging   Clutch not disengaging EmptyFri Jun 20, 2014 9:58 am

Normal you are sliding multiple disk coated with oil.
Back to top Go down
Gath3r13

Gath3r13



Clutch not disengaging Empty
PostSubject: Re: Clutch not disengaging   Clutch not disengaging EmptyFri Jun 20, 2014 10:55 am

Excellent. TY
Back to top Go down
Sponsored content





Clutch not disengaging Empty
PostSubject: Re: Clutch not disengaging   Clutch not disengaging Empty

Back to top Go down
 
Clutch not disengaging
Back to top 
Page 1 of 1
 Similar topics
-
» How to replace clutch plates? (clutch, gears not working)
» REV-LOK clutch
» OEM clutch replacement. Tusk clutch kit (review)
» Clutch 101
» Pulling the clutch

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: