Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 coolant replacement

Go down 
2 posters
AuthorMessage
laz749s

laz749s



coolant replacement Empty
PostSubject: coolant replacement   coolant replacement EmptySun May 03, 2015 10:36 am

I need to replace the coolant in my O8WR250X. What is the best way to drain it? Thanks for any help.
Back to top Go down
waltermitty





coolant replacement Empty
PostSubject: Re: coolant replacement   coolant replacement EmptySun May 03, 2015 11:38 am

Pretty simple. Remove set screw on radiator cap, remove cap, remove bottom 8mm bolt on water pump housing (one with copper washer). Coolant will drain out.

On left side remove the cover over coolant tank. Remove the two bolts and remove the coolant tank. Dump out coolant and give it a wash and replace.

Probably a good idea to flush the system with distilled water.

To get a 50/50 mix you need about 19 oz of straight coolant. Add this to the radiator and top up with distilled water. Add distilled water to coolant tank to get it between the lines. Be gentle with the drain bolt Torque is 86 inch/lbs.
Back to top Go down
 
coolant replacement
Back to top 
Page 1 of 1
 Similar topics
-
» Seeping Coolant
» Coolant Flush?
» low coolant
» Coolant Change Q
» Two coolant leaks

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: