Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 usb port

View previous topic View next topic Go down 
AuthorMessage
michiko




PostSubject: usb port   Sat Jul 11, 2015 8:21 am

just attached a usb port to the bike but i ve wired it directly to the battery. is there a simple way to wire it so it only comes on when i turn the ignition on?
Back to top Go down
speersie

avatar


PostSubject: Re: usb port   Sun Jul 12, 2015 5:22 am

michiko wrote:
just attached a usb port to the bike but i ve wired it directly to the battery. is there a simple way to wire it so it only comes on when i turn the ignition on?

You can use a relay and tap it in but by far the easiest is if you have installed the DRC tail light assembly you remove the old numberplate light so there is a free wire waiting for you.

There are plenty of way this is just a simple easy one but remember to put a fuse on it.
Back to top Go down
rarepartbuilder

avatar


PostSubject: Re: usb port   Sun Jul 12, 2015 11:04 am

i like using the cheap bosch relay method,,, that way nothing gets accidently left on when the bike is shut off..

the WR license plate wire makes a great power source tap  to energize the relay as the switched power source.

how to HERE

like speersie said... + 1 is using the fuse!!
Back to top Go down
dmmcd

avatar


PostSubject: Re: usb port   Wed Jul 22, 2015 9:03 am

Since I have my USB charger on the handle bars, I tapped into the front running lights (blue wire going to turn signals I think) to switch a relay circuit for all my accessories.
Back to top Go down
Sponsored content




PostSubject: Re: usb port   

Back to top Go down
 
usb port
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» PGA Village, Port St. Lucie Florida
» Standard port timings
» Where to find A/C Recharge Port -96 Rivi
» Edelbrock PCV vacuum the same as the Power Steering vacuum port?
» NSW - Port Macquarie Swap Meet

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: