Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 New Stator, but Now Hesitates Down Low

View previous topic View next topic Go down 
AuthorMessage
RapidRoy




PostSubject: New Stator, but Now Hesitates Down Low   Thu Aug 27, 2015 8:09 pm

I took my WR250R in to get the stator replaced under recall, but now I feel a bit of a hesitation down low. I suppose it could be the stator sapping a bit of the power at the lower RPMs but I can't image it would be any worse than the prior stator, which seemed to work fine. Any ideas on what might have occurred at the dealership during the replacement of the stator to cause this? I'm stumped. GAHHHH
Back to top Go down
Jens Eskildsen




PostSubject: Re: New Stator, but Now Hesitates Down Low   Fri Aug 28, 2015 4:04 pm

The stator isnt "removing power" from the bike.

Adjust CO settings and set the TPS. Theres guides for that inhere.
Back to top Go down
 
New Stator, but Now Hesitates Down Low
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» New Stator, but Now Hesitates Down Low
» Rewound stator voltage output??
» Do you think my stator had gone bad?
» Stator output
» What do the two wire from a stator do and where do I connect them?

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: