Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

Welcome to the WRR/X Forum :: General :: WRR/X General Discussion
 

 Stock hubs. Heavy?

Go down 
3 posters
AuthorMessage
MXTech935





Stock hubs. Heavy? Empty
PostSubject: Stock hubs. Heavy?   Stock hubs. Heavy? EmptyThu Oct 29, 2015 12:39 pm
Hi everyone,

I cracked the rear hub on my RR and was wondering if I should replace with a stock unit or aftermarket? I would like to save some weight if possible, but I can't tell if the stock hubs are aluminum or not...
Back to top Go down
woofer2609





Stock hubs. Heavy? Empty
PostSubject: I believe the stock ones are cast aluminum....   Stock hubs. Heavy? EmptyThu Oct 29, 2015 3:05 pm
A machined one from a block of billet will likely be stronger, or suffer fewer imperfections that would (did) lead to failure.
Back to top Go down
WROC

WROC



Stock hubs. Heavy? Empty
PostSubject: Re: Stock hubs. Heavy?   Stock hubs. Heavy? EmptyTue Nov 24, 2015 7:42 pm
The stock hubs are already pretty light. But, if you happen to be rebuilding your wheel anyway, replace the stock steel nipples with aluminum ones.
Back to top Go down
Sponsored content





Stock hubs. Heavy? Empty
PostSubject: Re: Stock hubs. Heavy?   Stock hubs. Heavy? Empty
Back to top Go down
 
Stock hubs. Heavy?
Back to top 
Page 1 of 1
 Similar topics
-
» Am I too heavy for a WRR?
» Hubs that fit WR250X?
» Powdercoated the Hubs + spoke nuts. Pics!!!
» 14/49 sprockets and 112 link chain
» Now playing at WR250R forum

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: General :: WRR/X General Discussion-
Jump to: