Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 Need help ..question on shock lowering/raising...

Go down 
2 posters
AuthorMessage
CRFan1





Need help ..question on shock lowering/raising... Empty
PostSubject: Need help ..question on shock lowering/raising...   Need help ..question on shock lowering/raising... EmptyTue Apr 19, 2016 11:37 am

So I picked up my new/used 2015 Sunday and I am dialing it in for me. I noticed that the guy I bought it from had the forks raised about an inch and a half and the rear shock mount clevis was turned all the way up (to the rebound adjuster). So....first order of business was putting the forks back to stock height and also adjusting the shock back to stock-ish (i.e unscrewing the clevis). The question I have is, how much thread should be showing? I guesstimated and I unscrewed the clevis until it was still threaded about half way through the clevis block. and tightened the lock nut. My rebound adjuster is at max (3 clicks from seated) and I want to say I have 3/4" of thread exposed although I did not measure it. Bike feels great I just want to make sure I did not unscrew the clevis too much etc. I am sure it is fine but just want to check......
Back to top Go down
Biglake





Need help ..question on shock lowering/raising... Empty
PostSubject: Re: Need help ..question on shock lowering/raising...   Need help ..question on shock lowering/raising... EmptyThu Apr 21, 2016 7:48 pm

There was another thread on this recently...

Theres 7 threads showing between the rebound adjuster and the clevis stock.

This info came in handy to me too as I went back to stock height on the rear suspension for a couple reasons, I mowed through a chain slider and have been doing a lot more rocky technical stuff where I need all the ground clearance I can get.
Back to top Go down
CRFan1





Need help ..question on shock lowering/raising... Empty
PostSubject: Re: Need help ..question on shock lowering/raising...   Need help ..question on shock lowering/raising... EmptyFri Apr 22, 2016 9:00 am

Thanks..yep someone did provide the link to the other thread. I was at 10 threads so I put it back to 7 and all good! thumb
Back to top Go down
Sponsored content





Need help ..question on shock lowering/raising... Empty
PostSubject: Re: Need help ..question on shock lowering/raising...   Need help ..question on shock lowering/raising... Empty

Back to top Go down
 
Need help ..question on shock lowering/raising...
Back to top 
Page 1 of 1
 Similar topics
-
» Need Help...Question on Shock lowering/raising.....
» Yamalink + OEM Max Lowering: Shock Kisses Swingarm Tunnel
» Lowering question
» Another lowering question
» A question about lowering...

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: