Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Fuel pump bolts

View previous topic View next topic Go down 
AuthorMessage
beer goggle

avatar


PostSubject: Fuel pump bolts   Tue Apr 05, 2016 11:12 am

I'm going to be fitting my recently received IMS 3gal tank, just wanted to know what the consensus is on tightening fuel pump bolts are. Sounds anal I know, but I don't want to thread the bolts so was wondering if anyone bothered using a torque wrench (4NM) to get the right tightness? I remember a bunch of peeps threading oil filter cover bolts on the CRFL forums.
Back to top Go down
Fuzzy Wrench

avatar


PostSubject: Re: Fuel pump bolts   Tue Apr 12, 2016 11:28 pm

when i installed my tank, i only tightened the bolts by hand, snug, a good snug....just keep going around, criss-cross, with a screwdriver type handle, not ratchet...
Back to top Go down
 
Fuel pump bolts
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» FS R1 Carbs R1 fuel pump
» fuel pump for 85 k100RT
» none start k100 intermitent spark and fuel pump runing without pressing the start button?
» Cheap fuel pump?
» fuel pump replacement

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: