Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Moose Racing Handguards for WRR?

View previous topic View next topic Go down 
AuthorMessage
rrarthur




PostSubject: Moose Racing Handguards for WRR?   Sun May 08, 2016 8:11 am

OK, Finally I get to pick my bike up on Wed. I am looking at handguards for it, and like the looks of the Moose Racing Contour handguards.

Does anyone here use these with stock levers, and bars. Do they fit? I like these the best, otherwise it's the ACERBIS
Back to top Go down
Biglake




PostSubject: Re: Moose Racing Handguards for WRR?   Sun May 08, 2016 2:01 pm

I have their MSR twins, they're identical except for the stickers, on protaper kx high bend alum bars, they fit great and stay put in tip overs.

No wrap around hand guard stays in place well in tip overs with the stock steel bars. There's no good way to fasten them in the end of the bar, you end up with a rubber adapter over the expandable bolt to make them work. I'd buy new bars while you are at it.thumb
Back to top Go down
 
Moose Racing Handguards for WRR?
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Pix of my X with knobbies.
» "Flex" hand guards
» Blackdog's WRR build
» wheel bearings?????
» Moose Racing Skid plate

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: General :: WRR/X General Discussion-
Jump to: