Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Helmet lock bolt size/thread pitch?

View previous topic View next topic Go down 
AuthorMessage
coyote223




PostSubject: Helmet lock bolt size/thread pitch?   Mon Jun 06, 2016 5:31 pm

I need to know what size and thread pitch, the small bolt for the helmet lock is? PO removed it and the bolts, so I don't have them. They are two different size bolts, I have figured the big one out, but can't find anything that screws into the smaller hole. Thanks for any help,,, thumb

ETA: It's a WR250R,,,
Back to top Go down
drbike




PostSubject: Re: Helmet lock bolt size/thread pitch?   Fri Jun 10, 2016 4:28 pm

The big counter sunk bolt is 6mm I believe standard pitch.....

the other hole is for the pin on the back of the lock mechanism itself....



http://www.partshark.com/oemparts/a/yam/54205a86f87002132cdd6d4d/frame



If I understand you correctly.

Back to top Go down
 
Helmet lock bolt size/thread pitch?
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» exhaust tip bolt size...
» Thread pitch on banjo for oil feed line
» Helmet lock
» Handguard bar end Bolt Size
» Helmet lock won't open

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: