Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 

 Using pc5 without a dyno

Go down 

PostSubject: Using pc5 without a dyno   Sat Jul 02, 2016 2:43 am

Hi, i am interested in adding a programmer. The pcv is definately looking good but can i tune it wothout a dyno? Seems like im depending on finding a map that i close to my setup.

Now i have no dyno close and the fmf programmer seems better in tuning ability at my state..
Back to top Go down

PostSubject: Re: Using pc5 without a dyno   Wed Nov 09, 2016 11:20 pm

hey buddy, Here is my map of my bike, it was dyno tuned. I have FMF can powerbomb K&N filter. also w/out dyno you can just change the values and upload map and see how the bike feels. just make small changes at a time, and save your maps and label changes.
Back to top Go down
Using pc5 without a dyno
Back to top 
Page 1 of 1
 Similar topics
» 2014 vs 2015 xp 1000 dyno Chart
» The 411 on the MSD Charge FI Controller for the Kawasaki Teryx
» Fox Podium Shocks up-grade
» MCX Turbo kit 900XP 148rwhp
» RZR XP Dyno results

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: Pipes 'n Programmers-
Jump to: