Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 

 Handlebar suggestions?

Go down 

PostSubject: Handlebar suggestions?   Tue Aug 23, 2016 7:30 pm

Hi guys, I'm looking for a bar that will directly replace my stocker, with as many similar dimensions EXCEPT sweep.  My wrists are feeling it on hard ride, and I think it is because the bars are swept to far back for my liking.  I have looked at the size charts on RMATVMC and I can't find any 7/8" bars that have less sweep than stock, except the mini ones that are much narrower.  Can anyone point me in the right direction?  Thanks!
Back to top Go down

PostSubject: Re: Handlebar suggestions?   Fri Aug 26, 2016 9:40 am

I have pro taper 7/8 kx high bend bars on mine, I only wanted taller not less sweep tho, they are the same sweep as stock.
I used the rmatvmc chart to pick my bars too. thumb

The pro taper factory Suzuki 7/8 bars will be 0.17 of an inch lower, 1/2 an inch wider with close to 1 inch less sweep, thats pretty close to stock height, I doubt you could tell the difference height wise.
Back to top Go down

PostSubject: Re: Handlebar suggestions?   Fri Aug 26, 2016 5:47 pm

I have the RC 7/8 http://www.renthal.com/shop/mx-products/handlebars/se-handlebars/mx-se-handlebars/rc-sehandlebar
A little taller with less back sweep.
Back to top Go down
Sponsored content

PostSubject: Re: Handlebar suggestions?   

Back to top Go down
Handlebar suggestions?
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: General :: WRR/X General Discussion-
Jump to: