Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 FMF programmer settings for Delta Barrel 4 exhaust

Go down 
AuthorMessage
Cookie Monster




PostSubject: FMF programmer settings for Delta Barrel 4 exhaust   Tue Aug 30, 2016 8:31 pm

Hi everyone,

Sorry for another programmer settings thread, but I have searched and can only find info for FMF exhausts. My bike came with a Delta Barrel 4 exhaust, and it seems to pop a lot on decel. It still has the AIS attached which I will be removing as soon as I get the block off plate, but I'm not sure if it's running lean otherwise.

It seems to run fine otherwise, other than some jerkiness at low RPM. I'm not sure if that's due to something off with the programmer or if it's because it's a low HP bike and I'm making it bog a bit. It also shut off on me once while I had the clutch in and rolling, and for a second or two on the highway today it seemed to cut out power for a bit before acting normal again. Other than a few hiccups here and there it runs fine but I'm hoping someone has a good map for the Barrel 4 exhaust with AIS and EXUP deleted (no airbox mods yet but I can do them if the map is tuned for it).

Thanks!
Back to top Go down
 
FMF programmer settings for Delta Barrel 4 exhaust
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: Pipes 'n Programmers-
Jump to: