Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Power commander FC accel pump

View previous topic View next topic Go down 
AuthorMessage
tomasn




PostSubject: Power commander FC accel pump   Sun Nov 20, 2016 2:51 pm

Anyone could share PC FC or V accelerator pump and throtlle settings? Have a little bog on low rpm. Internet doesn't show any information about setting up this PC V feature
Back to top Go down
blusmoke




PostSubject: Re: Power commander FC accel pump   Tue Nov 29, 2016 8:14 pm

its been a while but i believe the accel pump is in a drop down menu at top of the window, you may have to poke around a bit and I think you must enable the feature in a separate drop down.

also set the sensitivity like 80% otherwise it unnecessarily dumps fuel
Back to top Go down
tomasn




PostSubject: Re: Power commander FC accel pump   Wed Nov 30, 2016 12:10 am

Found custom map on the internet and it works absolutely sweet with 25% throttle, 10% fuel and 40% revs. May be it'll work without Accel pump too, but didn't had time to do this
Back to top Go down
Sponsored content




PostSubject: Re: Power commander FC accel pump   

Back to top Go down
 
Power commander FC accel pump
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Power commander FC accel pump
» Power Commander FC?
» POWER COMMANDER FOR 1250
» power commander
» Installed my new Power Commander

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: Pipes 'n Programmers-
Jump to: