Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Adjusting Throttle Position Sensor (TPS) on WR250R - Video

View previous topic View next topic Go down 
AuthorMessage
mo_rider




PostSubject: Adjusting Throttle Position Sensor (TPS) on WR250R - Video   Sun Jan 15, 2017 5:10 pm

After being a bit frustrated with the "snatch" of the throttle on my WR250R, I did some research (mainly from this forum) and decided to give adjusting the TPS a go.  Below is a video I made showing how I adjusted the TPS using a low-profile ratcheting bit wrench I found on Amazon with a cut-down t-25 torx bit.  Hope someone finds it helpful.

Video:  https://www.youtube.com/watch?v=sidLqlHtH-E
Low-profile ratcheting bit wrench:  https://www.amazon.com/Neiko-03044A-Ratcheting-Screwdriver-Close-Quarters/dp/B000XYOUS6/

After going from 15 to 19/20, the throttle snatch is a bit better at low speed and the engine braking doesn't seem as exaggerated as it was before.  I'm happy with the results but will probably be looking to a fuel programmer in the future to see if it helps any.
Back to top Go down
Elm




PostSubject: Re: Adjusting Throttle Position Sensor (TPS) on WR250R - Video   Mon Jan 16, 2017 4:33 am

Thanks for the Video & persistence with a difficult task but, GAHHHH , get rid of those boxing gloves and get some nice thin Nitrile gloves for your next task.
Back to top Go down
 
Adjusting Throttle Position Sensor (TPS) on WR250R - Video
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Adjusting Throttle Position Sensor (TPS) on WR250R - Video
» Secondary Throttle Position sensor
» throttle position sensor
» Throttle position sensor
» K100RS Injection woes

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: