WR250R seat mods

I will get this thread started with some pics of my brand spanking new Renazco Racing seat.

Gargoyle wrote:

I will get this thread started with some pics of my brand spanking new Renazco Racing seat.

That's a nice looking seat. I put a Corbin on because it helps me reach the ground, but it's kind of a pain having it slant toward the tank. The Renazco looks much flatter on top.

Nice seat... and nice car

Porsche?

mtb wrote:

Nice seat... and nice car

Porsche?

Heh ... I was so focused on the seat ... didn't realize I even had the front corner in that shot.

It's a 2006 Cayenne Turbo ... zaroooooooommmmmmmmm!!!

Gargoyle wrote:

Heh ... I was so focused on the seat ... didn't realize I even had the front corner in that shot.

It's a 2006 Cayenne Turbo ... zaroooooooommmmmmmmm!!!

Your focus is alright

It's just... being a software engineer, sometimes I have to look at the same thing from different angles, and THAT corner just caught me

Is it easy to clean the surface of the seat? It looks like a tough job

That looks awesome!! How much wider is it than stock?

asheville thumper wrote:

How much wider is it than stock?

Same width ... they use the stock plastic seat base for the re-build.

mtb wrote:

Is it easy to clean the surface of the seat? It looks like a tough job

I choose to get a suede seat top. There are 3 choices of material. But I went with suede because I know it grips well and is warmer in the cold and cooler when it's hot out. So you clean it when dry with a suede brush. If it's really really dirty you can wash it. And they suggest using a water proofing liquid made especially for suede as well. I have seen these seats on other dual sport bikes that have been through the same terrain and wet conditions I ride in ... and the seats hold up very well if taken care of.

I am a bit afraid to ask but How mucheee Money?

0007onWR wrote:

I am a bit afraid to ask but How mucheee Money?

I think it was $400.