Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 

 Handlebar Specs

Go down 


PostSubject: Handlebar Specs   Tue Nov 09, 2010 8:48 pm

i am somewhat familiar with the bends of handlebars having looked at the helpful chart at rockymountainatv. however i failed to find a comparison to the stock bars so i was wondering if anyone has the specs for the rise and such of the stock bars
Back to top Go down

PostSubject: Re: Handlebar Specs   Wed Nov 10, 2010 10:06 am

Copy and paste from RichardU over on Advrider:

Stock bars are 30.7" W, 3.8" H, 2.6" Pull Back.

Back to top Go down


PostSubject: Re: Handlebar Specs   Fri Nov 12, 2010 3:45 pm

thanks thumb i'll put this to good use
Back to top Go down


PostSubject: Re: Handlebar Specs   Mon Jun 06, 2016 10:44 pm

I had to convert the measurements from inches to mm. Figured I'd share it.

Stock 779.78 W, 96.52 H, 66.04 Pullback.
Back to top Go down

PostSubject: Re: Handlebar Specs   Wed Jun 29, 2016 10:00 pm

I just got some Ricky Carmichael Renthal handlebars, look very similar in bend and sweep to stock
Back to top Go down

PostSubject: Re: Handlebar Specs   Wed Sep 13, 2017 8:33 pm

Thanks for the advice everyone. I ended up going with the Pro Taper Henry/Reed bend. They're ok. I'm not crazy about them, from a bend perspective (especially the sweep). The product itself is great quality.

For some reason, the link to the Zeta handlebar simulator got missed, so thanks for sending that. It is funny how our stock bars are a supermoto bend, according to Zeta.
Back to top Go down
Sponsored content

PostSubject: Re: Handlebar Specs   

Back to top Go down
Handlebar Specs
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: Sweet Mods & Bike Accessories-
Jump to: