Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Head light plastic

View previous topic View next topic Go down 
AuthorMessage
bsheet2

avatar


PostSubject: Head light plastic   Sat May 28, 2011 6:06 pm

Dropped the bike and the little plastic shield that was above the headlight poped off. No damage that I can see. But the dang thing will not snap back on. It there some sort of clips or something that I lost??
Back to top Go down
Bikeman




PostSubject: Re: Head light plastic   Sat May 28, 2011 7:04 pm

I nailed a tree on the trail last weekend and did the same. There should be two small pegs at the top corners that go into two small holes in the headlight surround and two small tabs at the bottom corners that go into the notches in the surround that are by the right/left headlight adjustment screws. Sounds like you snapped some of these off. I ddi and just applied Velcro to it and reattached. Could also easily rivet it to the headlight surround and still be able to get to the headlight surround attachment bolts if needed, this is what I will do if Velcro doesn't hold.
-Bikeman
Back to top Go down
bsheet2

avatar


PostSubject: Re: Head light plastic   Sat May 28, 2011 7:29 pm

Thanks for the reply.

The small pegs at the top are still there. They just don't seem to snap in and hold. I can't see that anything has been broken off.
Back to top Go down
f3joel

avatar


PostSubject: Re: Head light plastic   Sat May 28, 2011 10:00 pm

There are little black washer looking things that snap on the pegs and hold it on.
Back to top Go down
bsheet2

avatar


PostSubject: Re: Head light plastic   Sat May 28, 2011 10:41 pm

f3joel wrote:
There are little black washer looking things that snap on the pegs and hold it on.

Ok. Thank you so much for the info. I think I know what those must look like.
Back to top Go down
Sponsored content




PostSubject: Re: Head light plastic   

Back to top Go down
 
Head light plastic
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Head light cover protector
» FS: 1980 Toyota Corolla quad head light front end
» Up grading Silverwing head light bulbs
» Head light conversion buckets
» Head Light Connector, Pigtail - Plug & Play

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: