Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 

 Need some bolt sizes

Go down 


PostSubject: Need some bolt sizes   Thu Jun 23, 2011 12:05 am

a: For the seat

b: for a skid plate

Thanks. Can't seem to find the right ones. They're probably Metric, right?
Back to top Go down
Alpha Rider

PostSubject: Re: Need some bolt sizes   Thu Jun 23, 2011 12:28 am

Yep. Seat bolts are 6mm pitch. Skid plate the front bolts are 10 mm...as for the rear unless you have the B&B I can't help you because this one uses the rear engine mount bolts. dunno

A wolf's voice echoed down the mountain 'Share the bounty of the hunt with your brothers and sisters, and forever be strong and free.'
Back to top Go down
Fuzzy Wrench


PostSubject: Re: Need some bolt sizes   Fri Jun 24, 2011 9:34 pm

pretty much everything on the bike is metric..
seat bolts M6x1.0,
skid plate, depends on brand, GYTR Yamaha is M6x1.0 also
Back to top Go down


PostSubject: Re: Need some bolt sizes   Mon Jun 27, 2011 5:33 pm

You're right, Fuzzy Wrench. Picked the bolts up at a local hardware store. Wish they had Allen key ones. Rolling Eyes

Tried to get some at my local Yamaha dealership - he told me he would have to special order them Suspect On the other hand it's that dealership that wanted to charge me 300 bucks for a checkup.
Back to top Go down


PostSubject: Bolts & Nuts   Tue Jul 05, 2011 5:50 pm

For $30 you can get a 180 piece metric assortment of motorcycle nuts and bolts from just about any motorcycle online parts store. Very worthwhile to have if you own a motorcycle! thumb
Back to top Go down
Sponsored content

PostSubject: Re: Need some bolt sizes   

Back to top Go down
Need some bolt sizes
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: