Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion
 

 Quick Tech Q's

Go down 
2 posters
AuthorMessage
gatorfan

gatorfan



Quick Tech Q's Empty
PostSubject: Quick Tech Q's   Quick Tech Q's EmptySat Jul 16, 2011 5:44 pm
1) Which side does the rear axle nut belong - chain or rotor side?

2) There are 2 metered spacers for the rear axle (with notches for adjusting the chain slack). One spacer has a slight flange on one side, the other is flat. Which side does the flanged spacer belong - chain or rotor?

Thanks.

Back to top Go down
mordicai





Quick Tech Q's Empty
PostSubject: Re: Quick Tech Q's   Quick Tech Q's EmptySat Jul 16, 2011 7:29 pm
Nut goes on the rotor side: The flange is to hold the head of the bolt to keep it from turning when you tighten the nut.


Last edited by mordicai on Sat Jul 16, 2011 8:58 pm; edited 1 time in total
Back to top Go down
gatorfan

gatorfan



Quick Tech Q's Empty
PostSubject: Re: Quick Tech Q's   Quick Tech Q's EmptySat Jul 16, 2011 8:11 pm
Thank you much.
Back to top Go down
mordicai





Quick Tech Q's Empty
PostSubject: Re: Quick Tech Q's   Quick Tech Q's EmptySat Jul 16, 2011 8:59 pm
gatorfan, The flange holds the head of the bolt not the nut as I misspoke.
Back to top Go down
Sponsored content





Quick Tech Q's Empty
PostSubject: Re: Quick Tech Q's   Quick Tech Q's Empty
Back to top Go down
 
Quick Tech Q's
Back to top 
Page 1 of 1
 Similar topics
-
» Alpinestars Tech 8
» Tech Bulletins
» A little help from my friends...tech day
» Trail Tech Vapor
» Trail-Tech Voyager

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: