Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Quick Tech Q's

View previous topic View next topic Go down 
AuthorMessage
gatorfan

avatar


PostSubject: Quick Tech Q's   Sat Jul 16, 2011 5:44 pm

1) Which side does the rear axle nut belong - chain or rotor side?

2) There are 2 metered spacers for the rear axle (with notches for adjusting the chain slack). One spacer has a slight flange on one side, the other is flat. Which side does the flanged spacer belong - chain or rotor?

Thanks.

Back to top Go down
mordicai




PostSubject: Re: Quick Tech Q's   Sat Jul 16, 2011 7:29 pm

Nut goes on the rotor side: The flange is to hold the head of the bolt to keep it from turning when you tighten the nut.


Last edited by mordicai on Sat Jul 16, 2011 8:58 pm; edited 1 time in total
Back to top Go down
gatorfan

avatar


PostSubject: Re: Quick Tech Q's   Sat Jul 16, 2011 8:11 pm

Thank you much.
Back to top Go down
mordicai




PostSubject: Re: Quick Tech Q's   Sat Jul 16, 2011 8:59 pm

gatorfan, The flange holds the head of the bolt not the nut as I misspoke.
Back to top Go down
Sponsored content




PostSubject: Re: Quick Tech Q's   

Back to top Go down
 
Quick Tech Q's
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Tech weekend at Jake Raby's shop
» grant quick release hub
» adams idea tech v3 or adams idea black super?
» home made quick release steering wheel???
» Ride Tech Air Suspension

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: