Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Need advice on which PCV map to use.

Go down 
AuthorMessage
Adamwn




PostSubject: Need advice on which PCV map to use.   Fri Oct 28, 2011 10:44 pm

Hello all, I'm new here, names Adam.
I just got my 2011 WRR a few weeks ago and I quickly got to work modding it with all the recomended mods.
My mods are:

Fmf Q4 muffler with MEGAbomb header
Power commander V
Top of air box removed
K&N filter
AIS, EXUP, flapper, CA canister gone
Edge tail light
Zeta hand guards with flashers
IMS pro series footpegs
Dunlop D606 tires
12/43 gearing, I have a blue GYTR 45 tooth rear but I'm holding off on installing it till I'm done with power mods so I don't throw my butt dyno off.

My question is what map should I run for my mods? Does anyone have my mods and autotune that could send me their autotune created map? I put the 006 map in for starters, it's for a full exhuast , stock filter and open air box door. BUT I have a k&n, with air box top removed and a totally different exhuast with the MEGABOMB.
So that map can't be perfect for my bike.. I rode around the block some and it seems to run hot with this map.
I know I should have it dyno tuned or buy auto tune but I thought I'd ask you guys what to do. Or if you know of a better map for me?
Back to top Go down
BuilderBob

avatar


PostSubject: Re: Need advice on which PCV map to use.   Sat Oct 29, 2011 9:45 am

Have you checked the Dynojet website?



The map you're using sounds like a good place to start, but without an Autotune module with O2 sensor or tuning on a Dyno, you'll just be guessing.
Back to top Go down
Adamwn




PostSubject: Re: Need advice on which PCV map to use.   Wed Nov 02, 2011 6:21 am

Yeah I got the map I'm using from their website.
Back to top Go down
Sponsored content




PostSubject: Re: Need advice on which PCV map to use.   

Back to top Go down
 
Need advice on which PCV map to use.
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: Pipes 'n Programmers-
Jump to: