Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Sprocket bolts getting loose

View previous topic View next topic Go down 
AuthorMessage
IAmABug




PostSubject: Sprocket bolts getting loose   Sat Aug 18, 2012 8:24 pm

I am doing a swap over of my rear sprockets today. As I went to loosen the bolts I found 10 of 12 were loose. So all you peeps out there may want to check yours every now and then. I am adding it to my weekly bolt checks. This was on my SM & Dirt setups.
Back to top Go down
MotoKirby




PostSubject: Re: Sprocket bolts getting loose   Sat Aug 18, 2012 11:13 pm

If they are comin loose you have a rear wheel alignment problem. Once loose, it is recommended you replace them.
Back to top Go down
chuckP




PostSubject: Re: Sprocket bolts getting loose   Sat Aug 18, 2012 11:20 pm

threadlocker works wonders on bikes
Back to top Go down
Sponsored content




PostSubject: Re: Sprocket bolts getting loose   

Back to top Go down
 
Sprocket bolts getting loose
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Sprocket bolts falling off?
» Using OE rear sprocket bolts on aftermarket TAPERED holes?!
» Rear Sprocket Bolts
» Rear Sprocket Bolts
» Tapered sprocket bolts

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: