Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Clutch install question

View previous topic View next topic Go down 
AuthorMessage
Potentate




PostSubject: Clutch install question   Fri Oct 19, 2012 7:25 pm

So I just replaced my clutch, (burnt the old one, my fault) I think I did everything by the numbers. When I pull the clutch lever it doesn't begin to engage until its about 1/2 pulled, and when the lever's all the way pulled it feels like its not completely disengaging the engine. With the clutch pulled and in gear I can feel significantly more resistance when I'm pushing the bike around the garage vs in neutral. Is this normal? I haven't even started the bike since the install because I just want an opinion on if I messed something up on the install before I try driving it.

Thanks
Eric
Back to top Go down
dragnframe




PostSubject: Re: Clutch install question   Mon Oct 22, 2012 9:01 am

Have you tried to adjusting the cable?
Back to top Go down
Potentate




PostSubject: Re: Clutch install question   Fri Oct 26, 2012 3:17 pm

Apparently I had the clutch springs torqued too tight. I thought I had them correct but after loosening and torquing them again it works fine. Learning has occurred! thumb
Back to top Go down
Sponsored content




PostSubject: Re: Clutch install question   

Back to top Go down
 
Clutch install question
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Brute Force Clutch Spring Question
» Dirty Dawg Clutch install
» K100RS Clutch Pushrod Question
» Clutch kit question
» zeta handguard throttle side install question

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: