Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 rear brake lever

View previous topic View next topic Go down 
AuthorMessage
LordMDP




PostSubject: rear brake lever   Fri May 17, 2013 3:44 pm

I've tried adjusting the rear brake lever down but its still not low enough for my liking

anyone else have this problems. i just put another brake pedal on so i know its not because its bent..
Back to top Go down
gatorfan

avatar


PostSubject: Re: rear brake lever   Fri May 17, 2013 4:17 pm

Ride Engineering sells a clevis that allows you to lower the pedal quite a bit. Click >> Ride Engineering Brake Clevis.

I assume these will do the same for less $$ but not sure ... Click >> Zeta Clevis

Here's a thread on it, though pics are down. Click >> Brake Lowering Thread

If you go that route would you kindly report back on your experience. Pics if possible.
Back to top Go down
chuckP




PostSubject: Re: rear brake lever   Fri May 17, 2013 8:59 pm

I was in the same boat. I ended up removing the nut and grinding down the clevis. Now it's just right.
Back to top Go down
Sponsored content




PostSubject: Re: rear brake lever   

Back to top Go down
 
rear brake lever
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Rear Brake lever
» Rear Brake Lever Adjustment
» rear brake pedal
» Part number for rear brake lever switch
» Knockoff Pazzo Bandit 1250 Brake Lever - Brand New Never Used $20

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: