Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 Can't Find Idle Adjustment Screw

View previous topic View next topic Go down 
AuthorMessage
Kannonball




PostSubject: Can't Find Idle Adjustment Screw   Sat Jul 13, 2013 9:49 am

I can't seem to find the idle adjustment screw on my 2012 WR anybody have a picture of its location and which side of the bike it's on?  Do I need to remove the seat and tank?  I would like to raise my idle just a bit but don't see a typical idle adjustment screw.
Thanks,
Bruce
Back to top Go down
Fuzzy Wrench

avatar


PostSubject: Re: Can't Find Idle Adjustment Screw   Sat Jul 13, 2013 10:00 am

i believe there is a phillips head screw on the lower part of the throttle body that you access from the left...
Back to top Go down
Kannonball




PostSubject: Re: Can't Find Idle Adjustment Screw   Sat Jul 13, 2013 12:05 pm

Thanks Fuzzy Wrench, It was right there. I was looking for a throttle plate position type adjuster like would be on a carbureted engine. Don't know what I was thinking - forgot that fuel injection would use and air bypass type adjustment - doh!
Thanks,
Bruce
Back to top Go down
Sponsored content




PostSubject: Re: Can't Find Idle Adjustment Screw   

Back to top Go down
 
Can't Find Idle Adjustment Screw
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» KTM 400 Mixture screw adjustment.
» Carb adjustment
» Rear adjustment links and tie rods for Riviera
» pilot screw
» A/F screw screwdriver

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: