Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 
 

 What is this sensor/switch?

View previous topic View next topic Go down 
AuthorMessage
rocketjump




PostSubject: What is this sensor/switch?   Mon Nov 11, 2013 7:22 pm

While changing my spark plug I found this thing hanging.  I did not poke at it so it might be a switch, not a sensor as I previously posted. I figure it is part of something that was removed (mine came without an AIS or EXUP), but I didn't remember seeing this sensor mentioned on WRRdualsport, ADV, here, or anywhere else.  I only know of the blue plug near the horn, from the AIS system.  I looked over a microfiche but I probably looked right at it without recognizing it.  Anywhere here it is, I appreciate the help!



Last edited by rocketjump on Mon Nov 11, 2013 8:38 pm; edited 1 time in total
Back to top Go down
YZEtc

avatar


PostSubject: Re: What is this sensor/switch?   Mon Nov 11, 2013 8:35 pm

Looks a lot like the switch that attaches to the clutch lever holder.
Back to top Go down
rocketjump




PostSubject: Re: What is this sensor/switch?   Mon Nov 11, 2013 8:37 pm

It does look like a switch more than a sensor, I guess I didn't poke it. I took this photo a while ago so I forget now. The bike came with an aftermarket clutch lever and perch so you are probably right. Thanks!
Back to top Go down
camaroz1985




PostSubject: Re: What is this sensor/switch?   Tue Nov 12, 2013 2:52 pm

Yeap that's definitely what it is. I'm betting if you have it in gear you can't start the bike, where if this was connected you could start it in gear with the clutch pulled.
Back to top Go down
rocketjump




PostSubject: Re: What is this sensor/switch?   Tue Nov 12, 2013 3:17 pm

camaroz1985 wrote:
Yeap that's definitely what it is.  I'm betting if you have it in gear you can't start the bike, where if this was connected you could start it in gear with the clutch pulled.
Yep I checked the perch and there is no switch there. Out of habit I always start it properly anyway, but at least now I know what it is! Thanks all.
Back to top Go down
Sponsored content




PostSubject: Re: What is this sensor/switch?   

Back to top Go down
 
What is this sensor/switch?
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» 2013 or newer Rzr Limp Mode Trail Fix
» K100RS 16v 1993 Throttle position switch
» Non-AC Alternator bracket and Water outlets with sensor hole. Los Angeles, CA
» Gear position switch
» WR250X not starting... run/stop switch was disconnected

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: