A little help with some measurements for a new guy.

Hello to all,

I want to make a motorcycle hitch carrier to pick up a wr250r from out of state and was wondering if someone can help me out with some measurements. The Height of the foot peg from the ground, (bottom and top of the peg). Measurement from the sidewall of the back tire to the end of the handlebar grip. Height of the handlebar from the ground. Measurement of the wheel base from axle to axle. Seat Height from the ground. I think that should cover my bases.

Thanks,
Everett.

Admin

I can't help - I've got a Yamalink and the factory lowering going on.

You need somebody with a box stock setup to get your measurements.

I'm here to help! I hope this is what you want.

TOP OF FOOTPEG TO GROUND:_____________13.5"
BOTTOM OF FOOTPEG TO GROUND__________12"
SIDEWALL OF BACK TIRE TO HANDLEBAR
GRIP (CENTER OF TIRE BELOW AXLE)________59.5"
HEIGHT OF HANDLEBAR GRIP TO GROUND
ON CENTER_______________________________46.5"
WHEELBASE (measured)_____________________56"
WHEELBASE (factory spec)___________________55.9"
SEAT HEIGHT (measured at low point)__________35.4"
SEAT HEIGHT (factory spec)__________________36.6"

PERFECT.......Thanks