Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 Error code 13

Go down 
3 posters
AuthorMessage
aron_vaski





Error code 13 Empty
PostSubject: Error code 13   Error code 13 EmptySun Nov 08, 2015 11:49 am

Yesterday, when I rode my bike, it shut down when I pulled the clutch in. I didn't start it a while, but when I turned it on, I saw 13 on the speedometer. I searched for it on Google, but I couldn't find a solution.
(Sorry for bad English, I'm from Hungary)
Back to top Go down
wwguy

wwguy



Error code 13 Empty
PostSubject: Re: Error code 13   Error code 13 EmptySun Nov 08, 2015 12:26 pm

From the service manual:

Fault code 13: Intake air pressure sensor-open or short circuit detected.

Probable cause of malfunction:
- Open or short circuit in wire harness.
- Defective intake air pressure sensor.
- Malfunction in ECU.
Back to top Go down
aron_vaski





Error code 13 Empty
PostSubject: Re: Error code 13   Error code 13 EmptySun Nov 08, 2015 2:24 pm

wwguy wrote:
From the service manual:

Fault code 13: Intake air pressure sensor-open or short circuit detected.

Probable cause of malfunction:
- Open or short circuit in wire harness.
- Defective intake air pressure sensor.
- Malfunction in ECU.
Can l fix it, and how? I checked the wiring of the sensor, it looks fine. What should I do?
Back to top Go down
wwguy

wwguy



Error code 13 Empty
PostSubject: Re: Error code 13   Error code 13 EmptySun Nov 08, 2015 2:54 pm

The service manual has instructions how to check the sensor, but the instructions are too complicated for me to copy here.

You might be able to find an electronic copy of the 364 page manual online somewhere. I know it's protected by copyright so links to pirated versions aren't listed here in this forum. (I purchased a paper hard copy from Yamaha.)

Otherwise you may need to take the bike to a Yamaha dealer.
Back to top Go down
Steve74

Steve74



Error code 13 Empty
PostSubject: Re: Error code 13   Error code 13 EmptyMon Nov 09, 2015 1:21 am

What's your email I will see if can send you a copy of the electronic manual
Back to top Go down
Sponsored content





Error code 13 Empty
PostSubject: Re: Error code 13   Error code 13 Empty

Back to top Go down
 
Error code 13
Back to top 
Page 1 of 1
 Similar topics
-
» Error codes 12 crankshaft position sensor and error code 30
» Error Code 21
» Error code 1
» error code 70?
» Error code 24 on display

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: