I dont know what i did. multi function display probs

So I was messing around with the "multi-function display" and brought up
the diagnostics screen. I then proceeded to push more buttons and even
forgot the original setting. Don't know what i did. low rpm f-i seems
to run smoother for some reason though. This is a completely stock
bike(as far as this is concerned) with no mods to any electrical/
engine. The service manual dosen't say much at all about this
whatsoever. So before I go make a fool of myself over nothin at the
local dealer.......WHAT DID I DO

You found the software equivalent of the pink wire?

That's awesome!

If you could reproduce this it would be worth a lot to all members here...

You probably stumbled onto the CO Mode. Read this thread....

https://wr250rforum.forumotion.com/wrr-general-discussion-f3/wr-taco-in-diagnostic-mode-t1141.htm?highlight=co+mode