Location of idle screw on (2013) WR250R?

I need some direction on where the idle screw is located on a (2013) WR250R. I looked for some screws near the throttle body. I see one screw which is next (to the right of) of a hexagonal bolt. Is this the one?

I am trying to raise the idle up as it is low and jolting when going on and off the throttle.

Pictures would be awesome!

I'm in the house so the best I can say is its on the left side of the TB, it's a Phillips head and has nothing to do with cables or linkage, it's an air bleed. Backing it out allows more air through the air bleed circuit.

You can adjust the idle however, if your focusing on the on/off throttle snatch, try adjusting the CO, get a programmer and/or adjust the TPS.

https://wr250rforum.forumotion.com/t1141-wr-taco-in-diagnostic-mode
https://wr250rforum.forumotion.com/t5568-throttle-on-off-at-idle