wr250r turn signal problem

Just bought a 08 wrr a couple days ago and so far I love the bike. Got a pretty good deal on it but it needs fork seals and the right rear blinker stays lit constant all the time. Left side works properly and the front right works but flashes fast. Checked all the connections I could find and the grounds. Almost seems like a contact in a relay stuck somewhere. I couldn't find a relay though. Any ideas? Thanks

elipryor wrote:

Just bought a 08 wrr a couple days ago and so far I love the bike. Got a pretty good deal on it but it needs fork seals and the right rear blinker stays lit constant all the time. Left side works properly and the front right works but flashes fast. Checked all the connections I could find and the grounds. Almost seems like a contact in a relay stuck somewhere. I couldn't find a relay though. Any ideas? Thanks

Are they the OEM bulb type or LED? If they are LED they could have a load resistor to adjust the flasher rate and it could be the cause of the problem possibly.

Stock relay is near battery.

They are factory bulbs but the front blinkers are after market with regular bulbs in them. They left the blue wire unhooked to them. Is there a relay separate from the flasher?

elipryor wrote:

They are factory bulbs but the front blinkers are after market with regular bulbs in them. They left the blue wire unhooked to them. Is there a relay separate from the flasher?  

I've never messed with mine but I am sure the blue wire is so it can be used as a running light.

Here this may help you to follow the ciruit.

" />

elipryor wrote:

They are factory bulbs but the front blinkers are after market with regular bulbs in them. They left the blue wire unhooked to them. Is there a relay separate from the flasher?  

Factory front signals only have two wires going to each.

Thanks for the schematic. That will be a big help. I will let you guys know if I get it figured out. Loving the bike so far. Rode it quite a bit over the weekend and it did exactaly what I was hoping.