Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  
WR250R/X Forum

Share | 

 Charcoal Canister Removal Finished - Photos

Go down 

PostSubject: Charcoal Canister Removal Finished - Photos   Tue Jun 07, 2016 9:13 pm

This is a well covered post in at least three forums, none of which that I found, have pictures.  For me this is critical as I am not an expert in mechanics, but happy to learn and apply what I learn.  

My need for removal is similar to most, I bought the Flatland Racing Skid Plate and my need for the plate is greater than my concern for emissions in this instance.  With that said I would like feedback on if this is an acceptable solution.  The filter at the end of the vent tube (canister in line) will be replaced when I find a better fit/solution.  The vacuum cap was straight forward.

Back to top Go down
Charcoal Canister Removal Finished - Photos
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: Technical :: General Maintenance Discussion-
Jump to: