Welcome to the WRR/X Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to the WRR/X Forum

A place to share your passion for the WR250R/X!
 
HomeHome  Latest imagesLatest images  SearchSearch  RegisterRegister  Log inLog in  
WR250R/X Forum

 

 FMF programmer settings help?

Go down 
3 posters
AuthorMessage
shep546





FMF programmer settings help? Empty
PostSubject: FMF programmer settings help?   FMF programmer settings help? EmptyTue Mar 26, 2013 5:28 pm

Hey guys, just got most of my bike put together so far I've done.

FMF programmer, Uni air filter, fmf powercore 4 (stock header) and AIS removal.. I left the flapper alone.

Can anyone recommend me good settings for this setup?
Back to top Go down
Biglake





FMF programmer settings help? Empty
PostSubject: Re: FMF programmer settings help?   FMF programmer settings help? EmptyTue Mar 26, 2013 8:21 pm

Fmfs or very close to them.
I went through this with mine.
I found dyno tuned settings (3-5-.5-8-4-4) on high fives site and tried them, they were too rich off the bottom and caused stumbling.
I leaned out the yellow mode one step at a time untill it ran good off the bottom.
The bike would also cut out while cruising down the road, setting the yellow/blue mode to 6 fixed that, this is a common issue.
I ended up at 3-3-.5-8-6-4
fmf recommends 3-2-.5-8-4-4
Start with one of those they should be fairly close then test and tune it to your likeing.
Back to top Go down
motokid
Moderator
motokid



FMF programmer settings help? Empty
PostSubject: Re: FMF programmer settings help?   FMF programmer settings help? EmptyWed Mar 27, 2013 5:48 am

Go Here: click me

There's a whole section devoted to such things.

deal

_________________
2008 WR250X
Gearing: 13t - 48t
Power Commander 5 / PC-V
Airbox Door Removed - Flapper glued - AIS removed
FmF Q4
Bridgestone Battlax BT-003rs
Back to top Go down
Sponsored content





FMF programmer settings help? Empty
PostSubject: Re: FMF programmer settings help?   FMF programmer settings help? Empty

Back to top Go down
 
FMF programmer settings help?
Back to top 
Page 1 of 1
 Similar topics
-
» FMF Programmer Settings
» Fuel Programmer with stock exhaust air box mod AIS and EXUP
» FMF fuel programmer settings
» The Official FI Mapping Area
» Help with FMF Programmer Settings ASAP

Permissions in this forum:You cannot reply to topics in this forum
Welcome to the WRR/X Forum :: General :: WRR/X General Discussion-
Jump to: