indicator flasher relay

put some LED indicators on my bike (08 wr250x) today and as expected they flash to fast. I have a 3 pin electronic led flasher relay here to swap in but am unsure where the stock flasher relay is.

is any1 abl to tell me its exact location/

cheers mike

to the right of the battery..

Where & how much was your flasher? Mine are too fast, too.

i bought it from a local Australian auto parts store cost me $35au.

Can get them on ebay easy enough you want to look for "3 pin Electronic flasher relay" or "LED flasher relay". Basically rather than being load sensitive to make the relay switch open/close an electronic relay has a small circuit board in it to control the relay going open/close so no matter how many lights or wattage they are they will always flash at the correct speed.

very easy to install, the 2 wires goin to the stock yamaha relay connect to the new relay and the 3rd pin is earthed straight to the battery. the new relay fits nice and snug in the stock location aswell.

I bought this one from Cycle Gear. It plugged right in.

http://www.cyclegear.com/spgm.cfm?L1=&L2=&L3=&L4=&item=PRC_SM-FRH1_G

Hi guys-

Newb here. Just sold my F4i and got the WR250x, and am loving it!

So, planning to upgrade to LED signals & the DRC tail kit. Am I understanding this right, that I can buy this flasher relay and avoid the fast-flash signals (without the need for adding those inline resistors)?

Just wanna confirm before buying.

Tx.

Krabill wrote:

I bought this one from Cycle Gear. It plugged right in.

http://www.cyclegear.com/spgm.cfm?L1=&L2=&L3=&L4=&item=PRC_SM-FRH1_G

Easy fix. . . have the same on my bike.